■Refresh:Clickthisbuttontorefreshallcurrentconnections.
■Addtodenylist:YoucanselectentriesfromtheConnectionStatuslistandaddthemtotheDenyList
to deny access. Please note that those checked connections will only be disconnected temporarily
andwillautomaticallytrytorelinkagain(IEExploreorQuickTimePlayer).Ifyouwanttoenablethe
denied list, please check Enableaccesslistltering and click Saveintherstcolumn.
■ Disconnect: If youwant to break off the current connections, please select themand click this
button. Please note that those checked connections will only be disconnected temporarily and will
automaticallytrytorelinkagain(IEExploreorQuickTimePlayer).
Enableaccesslistltering: Check this item and click Saveifyouwanttoenabletheaccesslistltering
function.
Filter Type
Select Allow or Denyastheltertype.IfyouchooseAllow Type, only those clients whose IP addresses
are on the Access List below can access the Network Camera, and the others cannot access. On the
contrary, if you choose Deny Type, those clients whose IP addresses are on the Access List below will
not be allowed to access the Network Camera, and the others can access.
Filter
Then you can add a rule to the following Access List. Please note that the IPv6 access list column will not
be displayed unless you enable IPv6 on the Network page. For more information about IPv6 Settings,
please refer to page 37 for detailed information.
There are three types of rules:
Single: This rule allows the user to add an IP address to the Allowed/Denied list.
Forexample:
Comments to this Manuals