Vivotek FD6111V User Manual download pdf (Page 61)

- 57 -

www.vivotek.com

T: 886-2-82455282

F: 886-2-82455532

Appendix

A. Troubleshooting

Status LED

After powering up, the Network Camera performs a self-diagnostic to detect any

hardware defects. The following table lists the LED patterns in general. In case of any

fatal error, the LED will blink in a pattern other than those below.

Condition LED Color

During self-diagnostic after power on Blinking in interchanged Green and Red

After power on and before network is

setup

Red LED is constantly ON and Green LED is OFF

After network is setup Red LED is constantly ON and Green LED

blinking every 0.5 second

Ethernet signal is lost Red LED is constantly ON and Green LED is OFF

No audio or speak only Red LED is constantly ON and Green LED

blinking every second

Reset and Restore

There is a button on the main board of the camera

inside the dome body as shown in the picture. It is

used to reset the system or restore the factory

default settings. Sometimes resetting the system

sets the system back to normal state. If the system

problems remain after reset, restore the factory

settings and install again.

RESET: Press the button once.

RESTORE: 1. Press the button continuously.

2. Plug in the power and wait for the self-diagnostic.

to run twice.

3. Release the button after both LEDs shut off. as

soon as the second self-diagnostic starts..

Restoring the factory

defaults will erase any

previous settings. Reset or

restore the system after

power on.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 92 93

No comments

Vivotek FD6111V User Manual Page 61