Vivotek IP3112/IP3122 User Manual download pdf (Page 9)

- 8 -

www.vivotek.com

Software installation

At the end of the hardware installation, users can use Installation Wizard program

included in the product CDROM to find the location of the Network Camera. There may

be many Network Cameras in the local network. Users can differentiate the Network

Cameras with the serial number. The serial number is the MAC address that is printed

on the labels on the carton and the back of the Network Camera body. Please refer to

the user’s manual of Installation Wizard for detail.

Once installation is complete, the Administrator should proceed to the next

section "Initial access to the Network Camera" for necessary checks and

configurations.

Initial Access to the Network Camera

Check Network Settings

The Network Camera can be connected either before or immediately after software

installation onto the Local Area Network. The Administrator should complete the

network settings on the configuration page, including the correct subnet mask and IP

address of gateway and DNS. Ask your network administrator or Internet service

provider for the detail information. By default the Network Camera requires the

Administrator to run installation every time it reboots. If the network settings are to

remain unchanged, disable the Install option. Refer to “Network settings” on the

System Configuration page for details. If any setting is entered incorrectly and cannot

proceed to setting up the Network Camera, restore the factory settings following the

steps in the “Troubleshooting” chapter of the Appendix.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 64 65

No comments

Vivotek IP3112/IP3122 User Manual Page 9