Vivotek PT3123 User Manual download pdf (Page 34)

- 33 -

www.vivotek.com

T: 886-2-82455282

F: 886-2-82455532

Network Settings

Any changes made on this page will restart the system in order to validate the changes.

Make sure every field is entered correctly before clicking on .

"Reset IP address at next boot", the default status is checked to avoid erroneous

entries during installation. This can be tedious having to perform software installation

whenever the Network Camera starts. Therefore, once the network settings, especially

the IP address, have been entered correctly, uncheck this option. If this option is

disabled, the Network Camera will skip installation at the next boot. The Network

Camera can automatically restart and operate normally after a power outage. Users

can run IP installer to check the IP address assigned to the Network Camera if the IP

address is forgotten or using the UPnP function provided by the Network Camera (MS

Windows XP provides UPnP function at Network Neighbors).

General

“IP address” This is necessary for network identification.

“Subnet mask” This is used to determine if the destination is in the same subnet. The

default value is “255.255.255.0”.

“Default router” This is the gateway used to forward frames to destinations in a

different subnet. Invalid router setting will fail the transmission to destinations in

different subnet.

“Primary DNS” The primary domain name server that translates hostnames into IP

addresses.

“Secondary DNS” Secondary domain name server that backups the Primary DNS.

HTTP

“Http port” This can be other than the default Port 80. Once the port is changed, the

User must be notified the change for the connection to be successful. For instance,

when the Administrator changes the HTTP port of the Network Camera whose IP

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 65 66

No comments

Vivotek PT3123 User Manual Page 34