Vivotek PT3123 User Manual download pdf (Page 49)

- 48 -

www.vivotek.com

T: 886-2-82455282

F: 886-2-82455532

Appendix

A. Troubleshooting

Status LED

After powering up, the Network Camera performs a self-diagnostic to detect any

hardware defects. The following table lists the LED patterns in general. In case of any

fatal error, the LED will blink in a pattern other than those below.

Condition LED color

During self-diagnostic after power on Blink in interchanged green and red

Ethernet signal is lost Red LED is blinking till Ethernet is detected

Before network is setup Steady green till IP address is confirmed

After network is setup Blink green every second

Any hardware failure Other patterns

Reset and Restore

At the left side of the camera there is a button

hidden in the pinhole as shown in the picture. It is

used to reset the system or restore the factory

default settings. Sometimes resetting the system

sets the system back to normal state. If the

system problems remain after reset, restore the

factory settings and install again.

RESET: Poke the wrench to click on the button.

RESTORE: 1. Poke the wrench to press on the

button continuously.

2. Wait for self-diagnostic to run twice.

3. Withdraw the wrench as soon as the second

self-diagnostic starts.

Restoring the

factory defaults

will erase any previous settings.

Reset or restore the system after

power on.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 65 66

No comments

Vivotek PT3123 User Manual Page 49