Vivotek NR7401 User Manual download pdf (Page 7)

VIVOTEK - A Leading Provider of Multimedia Communication Solutions

User's Manual - 7

Reboot: Press and release the indented reset button� All status LED will extinguish and then

power on again. Wait for the Status LED to blink and then become steady green in normal state.

It takes about 30 seconds to complete the procedure�

Restore: Press the reset button continuously for over 3 seconds� All status LED will extinguish

and then power on again. Wait for the Status LED to blink and then become steady green in

normal state� Note that all settings will be restored to factory default� It takes about 50 seconds

to complete the procedure�

Installation

Hard Disk installation

Before using the Network Video Recorder, the rst step is to install a SATA hard disk for re-

corded video� Please follow the steps below:

1� Make sure the power is off�

2. Use a screwdriver to loose ve screws, and then slide to remove the upper cover.

3� Loose the screw and take out the hard disk bracket�

4� Put your hard disk into the bracket, and secure it with the supplied four screws�

5� Place your hard disk into the Network Video Recorder�

6� Slide the hard disk as the picture shows, and then secure it with the original screw�

7. Attach the upper cover, and then secure it with the original ve screws.

NOTE

► Please remember to format the hard disk

before strating recording� Please refer to

maintenance on page 37�

Power POE Status HDD WAN LAN1 LAN2 LAN3 LAN4

NR7401 Network Video Recorder

Steady green in normal state

1 2 3 4 5 6 7 8 9 10 11 12 ... 50 51

No comments

Vivotek NR7401 User Manual Page 7