Vivotek PZ6122 User Manual download pdf (Page 63)

- 59 -

www.vivotek.com

T: 886-2-82455282

F: 886-2-82455532

Appendix

A. Troubleshooting

Status LED

After powering up, the Network Camera performs a self-diagnostic to detect any

hardware defects. The following table lists the LED patterns in general. In case of any

fatal error, the LED will blink in a pattern other than those below.

Condition LED color

During self-diagnostic after power on Blink in interchanged green and red

Ethernet signal is lost Red LED is off till Ethernet is detected

Before network is setup Steady green till IP address is confirmed

After network is setup Blink green every second

Any hardware failure Other patterns

Reset and Restore

At the left side of the camera there is a button

hidden in the pinhole as shown in the picture.

It is used to reset the system or restore the

factory default settings. Sometimes resetting

the system sets the system back to normal

state. If the system problems remain after

reset, restore the factory settings and install

again.

RESET: Poke the wrench to click on the button.

RESTORE: 1. Poke the wrench to press on the

button continuously. 2. Wait for self-diagnostic.

During the diagnostic period, the red & green

lights will flick for several times. 3. Withdraw

the wrench when all the lights are off.

Restoring the factory defaults

will erase any previous settings.

Reset or restore the system after

power on.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 92 93

No comments

Vivotek PZ6122 User Manual Page 63