Vivotek PZ6122 User Manual Page 8

  • Download
  • Add to my manuals
  • Print
  • Page
    / 93
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 7
- 4 -
www.vivotek.com
T: 886-2-82455282
F: 886-2-82455532
Installation
Hardware Installation
Please verify that your product package
contains all the accessories listed in the
foregoing Package Contents. Depending on
the user’s application, an Ethernet cable may
be needed. The Ethernet cable should meet the
specs of UTP Category 5 and not exceed 100
meters in length.
Connect the power adapter jack to the
Network Camera before plugging in to the
power socket. This will reduce the risk of
accidental electric shock.
Upon powering up, the device runs through a self-test procedure and the front LEDs
will blink between green and red for a few times. If self-test passes, the LEDs will shut
off and the Network Camera will be on stand-by and ready for software installation. If
self-test fails the red LED will blink several times. Refer to Appendix A for
troubleshooting.
To install in Ethernet
Make sure the Ethernet is firmly connected to a switch hub. After attaching the
Ethernet cable plug in the power adapter. If the LED turns out to be steady green after
self-test, go to next paragraph “Software Installation”.
Page view 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 92 93

Comments to this Manuals

No comments