Vivotek VS2403 User Manual download pdf (Page 58)

- 57 -

www.vivotek.com

A.2 System recovery

Video Server provides an auxiliary button located on the left of the front panel for system

recovery by hardware. The buttons can be used to perform either level of system

recovery. “Reset” will force the system restart at any point; “Restore” will restore the

default settings from factory and then force the system restart to work at the initial state.

Consequently “restore” is generally used to completely recover the system from serious

fault in configuration.

RESET

Click on the “RESET” button once. The system will perform the system diagnosis and the

software installation may be necessary if the IP address is not fixed. This procedure is as

same as removing the power and attaching it again.

RESTORE

When the system seems to respond or operate slowly after changing some settings and

administrators hardly enter the configuration to change back the original settings,

administrators can perform the “restore” procedure. It is as same as the “factory

default” link on the configuration page. To restore the factory default settings, press the

“RESET” button firmly. The system diagnosis will start right away and the “status” LEDs

will be turn on after system diagnosis. After the “status” LEDs are off, Administrators can

release the “RESET” button now and perform the installation for the initialized system.

To reduce the system failure caused by operation error, always read the related

sections in this user’s manual to prevent from unexpected error caused by wild-guess

configuration.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 83 84

No comments

Vivotek VS2403 User Manual Page 58