Vivotek DVR ND8301 User Manual download pdf (Page 16)

VIVOTEK

16 - User's Manual

Initial Conguration

1. The system power on self test and OS initialization takes about 2 minutes to complete. Once

your NVR is started, you will be prompted by the Setup Wizard. You should then begin the

initial setup. The system is booted from an embedded IDE ash. No software installation is

required.

2. Enter the default User name and Password as admin & admin. It is recommended you

change the password later to prevent unauthorized access.

3. Click Next to proceed with conguration and follow the onscreen instructions to nish the

conguration process.

4. Note the following when you move to the Network page:

4-1. If your local network has a DHCP server, you can select the "Get IP address

automatically (DHCP)."

4-2. If your LAN port connects to an isolated switch with cameras attached to it, you can

manually assign IP addresses to cameras, and the address for the LAN port itself.

The default static IP for the LAN port is 192.168.1.10.

During boot-up, a Startup Menu will prompt allowing you to restore system to factory defaults.

This function is only required in circumstances that you need to renew all system settings, such

as moving the NVR to a different installation site or network environment.

NOTE:

1. NVR System

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 211 212

No comments

Vivotek DVR ND8301 User Manual Page 16