Vivotek FD8166 Installation Guide

EN - 9EnglishWARNINGDo not use your hands to tune the lens module's tilt angle. Doing so will damage the delicate tilt mechanism.1. There is a ti

EN - 105. Use a piece of clean cotton cloth to hold and install the dome cover. 6. Install dome cover by aligning the semi-circular cut-out with the r

2MP • Stylish Design • Easy InstallationAll specications are subject to change without notice. Copyright 2013 VIVOTEK INC. All rights reserved. c

Contact your distributor in the event of occurrence.Keep the Network Camera away from water. If the Network Camera becomes wet, power off immediately.

EN - 2500024701GScrews FD8166Quick Installation Guide /Warranty CardSoftware CDPackage Contents1NOTE: All cables are user-supplied. Use a CAT5 standar

EN - 3EnglishOuter ViewPhysical Description2Leave the slide cover in place if you route cables through the bottom and then through a hole on the ceili

EN - 4Hardware Installation3Removing the Dome Cover1. Use one hand to hold the camera bottom and another hand to hold the dome cover. Press the releas

EN - 5EnglishMounting the Network Camera - Ceiling or Wall Mount1. Use the curved slots on the camera as a template to mark where holes will be drill

EN - 6Network Deployment4Power over Ethernet (PoE)POWERCOLLISIONLINKRECEIVEPARTITION12345PoE SwitchWhen using a PoE-enabled switchThis Network Camera

EN - 7EnglishAssigning an IP Address50002D10766AD21. Install “Installation Wizard 2” from the Software Utility directory on the software CD.2. The p

EN - 8For further setup, please refer to the user's manual on the software CD.Ready to Use 61. A browser session with the Network Camera should