Vivotek 63E-M User Manual download pdf (Page 20)

VIVOTEK

20 - User's Manual

General Connection

HD WDR Pro

1. Connect the Network Camera's Ethernet cable (CAT5e) to a PoE Plus switch. A 30W PoE

output port alone can not drive the onboard heater, and hence if using the PoE switch alone,

the application does not apply in low-temperature condition. 30W PoE plus can only drive the

camera when it is working at a temperature higher than -5ºC.

HD WDR Pro

When using a non-PoE switch

Use a High Power PoE power injector (separately purchased) capable of 60W output to connect

between the Network Camera and a non-PoE switch. Sufcient power is required for low tem-

perature conditions when the onboard heater is activated.

Non-PoE Switch

High Power PoE

Power Injector

2. Connect the power wires to an AC 24V power adaptor (user-supplied). The AC 24V adapter

can drive the camera and the onboard heater.

You can connect both power sources for redundancy in power supply.

Power over Ethernet (High Power PoE)

AC 24V 3.5A Adapter

(User-supplied)

IEEE 802.3at PoE Switch (30W output)

and / or

Internet connection with static IP

Choose this connection type if you are required to use a static IP for the Network Camera.

Please refer to LAN on page 66 for details.

Internet connection via PPPoE (Point-to-Point over Ethernet)

Choose this connection type if you are connected to the Internet via a DSL Line. Please refer to

PPPoE on page 67 for details.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 215 216

No comments

Vivotek 63E-M User Manual Page 20