Vivotek RX7101 User Manual download pdf (Page 11)

- 10 -

www.vivotek.com

T: 886-2-82455282

F: 886-2-82455532

Initial Access to the Video Receiver

Check Network Settings

The Video Receiver can be connected either before or immediately after software

installation onto the Local Area Network. The Administrator should complete the

network settings on the configuration page, including the correct subnet mask and IP

address of gateway and DNS. Ask your network administrator or Internet service

provider for the detail information. By default the Video Receiver requires the

Administrator to run installation every time it reboots. Please refer to “Network

settings” on the System Configuration page for details. If any setting is entered

incorrectly and cannot proceed to setting up the Video Receiver, restore the factory

settings following the steps in the “Troubleshooting” chapter of the Appendix.

Add Password to Prevent Unauthorized Access

The default Administrator’s password is blank and the Video Receiver initially will not

ask for any password. The Administrator should immediately implement a new

password as a matter of prudent security practice. Once the Administrator’s password

is saved, the Video Receiver will ask for the user’s name and password before each

access. The user name for the Administrator is permanently assigned as “root”. Once

the password is changed, the browser will display an authentication window to ask for

the new password. Once the password is set, there is no provision to recover

the Administrator’s password. The only option is to restore to the original

factory default settings.

How to Use

Authentication

After opening the Web browser and typing in the URL of the Video Receiver, a dialogue

window pops up to request a username and password. Upon successful authentication,

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 49 50

No comments

Vivotek RX7101 User Manual Page 11