Vivotek RX7101 User Manual download pdf (Page 22)

- 21 -

www.vivotek.com

T: 886-2-82455282

F: 886-2-82455532

Network settings

Any changes made on this page will restart the system in order to validate the changes.

Make sure every field is entered correctly before clicking on

Network type

“LAN” & “PPPoE”

The default type is LAN. Select PPPoE if using ADSL

"Get IP address automatically" & “Use fixed IP address”

The default status is “Get IP address automatically”. This can be tedious having to

perform software installation whenever the Video Receiver starts. Therefore, once the

network settings, especially the IP address, have been entered correctly, select “Use

fixed IP address” then the Video Receiver will skip installation at the next boot. The

Video Receiver can automatically restart and operate normally after a power

outage. Users can run IP installer to check the IP address assigned to the Video

Receiver if the IP address is forgotten. “IP address” This is necessary for network

identification.

“Subnet mask” This is used to determine if the destination is in the same subnet. The

default value is “255.255.255.0”.

“Default router” This is the gateway used to forward frames to destinations in a

different subnet. Invalid router setting will fail the transmission to destinations in

different subnet.

“Primary DNS” The primary domain name server that translates hostnames into IP

addresses.

“Secondary DNS” Secondary domain name server that backups the Primary DNS.

“PPPoE” If using the PPPoE interface , fill the following settings from ISP

“User name” The login name of PPPoE account

“Password” The password of PPPoE account

“Confirm password” Input password again for confirmation

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 49 50

No comments

Vivotek RX7101 User Manual Page 22