Vivotek VS3102 User Manual download pdf (Page 12)

www.vivotek.com

T: 886-2-22404099

F: 886-2-22404097

Status LEDs

Each time VisualServer starts, it will perform a Power-On Self Test, abbreviated as POST hereafter, to

examine every hardware module. As soon as the administrator plugs in the power adapter, both LEDs

under the network LED will flash one by one until the POST is done. If any module fails, both LEDs will

indicate to the users the error according to the pattern listed in Appendix A. If the result is good, both

LEDs will turn off for a while and then follows the pattern below. Network interface depends on the

peripherals including Ethernet UTP cable, modem or null modem cable. If the Ethernet cable between

VisualServer and Ethernet hub is good, VisualServer will choose the Ethernet network. If Ethernet is

unavailable but a operational modem is connected, the network interface will be PPP with modem. If

either of the above is not the case, VisualServer will try the interface of PPP with null modem.

Network Interface Condition LED2 (Heartbeat) LED3 (Status)

before installed OFF OFF

after installed flash OFF

Ethernet

during camera control flash Flash

PPP with modem after POST flash ON

before connected ON ON PPP with null modem

after connected flash ON

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 97 98

No comments

Vivotek VS3102 User Manual Page 12