Vivotek VS3102 User Manual download pdf (Page 17)

www.vivotek.com

T: 886-2-22404099

F: 886-2-22404097

Software configuration

Easy way with installer program

In order to configure VisualServers remotely, administrators should keep the serial numbers of the new

VisualServers for identification and initial passwords. After successfully mounting VisualServers in the

proper position, run the Installer program on the appropriate PC to locate the newly installed

VisualServers. VisualServers also support manual setup procedures to non-Windows based environments.

The manual procedure is described next.

After the POST is done, VisualServer will try to configure itself by detecting the network environment. If

there is DHCP service over the network, the Installer program will catch the given information and

display the serial number and given IP address for each VisualServer as following figure. If no DHCP

service is available, a previous IP address will be displayed instead. In that case, it may be 0.0.0.0 for a

brand new unit. When multiple units are mounted, there may be several entries shown in the window.

Administrators may click on each entry with "Assigned" field labeled "No" to install sequentially.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 97 98

No comments

Vivotek VS3102 User Manual Page 17