Vivotek IP7152 User Manual download pdf (Page 65)

- 64 -

www.vivotek.com

T: 886-2-82455282

F: 886-2-82455532

Restoring the factory

defaults will erase any previous

settings. Reset or restore the

system after power on.

Appendix

A. Troubleshooting

Status LED

The following table lists the LED patterns in general.

Condition LED color

Loading system after power on Steady green and blink red (once)

During booting procedure Blinking red

Detecting and setting network Steady green till IP address is confirmed

After network is setup (system up) Blinking green every other second

and

steady red

During the upgrade firmware process Blink green / orange every second and fast

blink red

Reset and restore

There is a button in the back of the Network Camera. It is used to reset the system or

restore the factory default settings. Sometimes resetting the system sets the system

back to normal state. If the system problems remain after reset, restore the factory

settings and install again.

RESET: Click on the button.

RESTORE:

1. Press on the button continuously.

2. Wait for self-diagnostic to run twice.

3. Free the button as soon as the second self-diagnostic starts.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 105 106

No comments

Vivotek IP7152 User Manual Page 65