Vivotek IP7135 User Manual download pdf (Page 7)

VIVOTEK - A Leading Provider of Multimedia Communication Solutions

User's Manual - 7

Installation

In this manual, "User" refers to whoever has access to the Network Camera, and

"Administrator" refers to the person who can configure the Network Camera and grant

user access to the camera.

Hardware installation

Please verify that your product package contains all the

accessories listed in the foregoing Package Contents.

Depending on the user’s application, an Ethernet cable

may be needed. The Ethernet cable should meet the specs

of UTP Category 5 and not exceed 100 meters in length.

Upon powering up, the front blue LED will become lighted first and then the device will go

through booting process. During the booting process, both blue and red LEDs will be on

and the Network Camera will standby for getting IP address. After getting IP Address, the

LED will blink blue every second.

The Network Camera will first detect Ethernet. During the process, the red LED of the

Network Camera will flash every second. Operating in either network mode, the blue LED

will flash every second as heartbeat to indicate alive.

To install in Ethernet

Make sure the Ethernet is firmly connected to a switch hub. After attaching the Ethernet

cable plug in the power adapter. If the LED turns out to be steady blue, go to next

paragraph “Software installation”. If the Ethernet is not available, Network Camera will

switch to wireless LAN mode.

Connect the power adapter jack to the Network

Camera before plugging in to the power socket. This will

reduce the risk of accidental electric shock.

1 2 3 4 5 6 7 8 9 10 11 12 ... 60 61

No comments

Vivotek IP7135 User Manual Page 7