Vivotek IP8152 User Manual download pdf (Page 187)

VIVOTEK

User's Manual - 187

iris auto Let the Network Camera control iris size.

open Manually control the iris for bigger size.

close Manually control the iris for smaller size.

speedlink 0 ~ 4 Issue speed link command.

gaptime 0~32768 The gaptime between two consecutive ptz commands for

device. (unit: ms)

return <return page> Redirect to the page <return page> after the parameter is

assigned. The <return page> can be a full URL path or

relative path according to the current path. If you omit this

parameter, it will redirect to an empty page.

8.10 ePTZ Camera Control (capability.eptz > 0)

Note: This request requires camctrl privileges.

Method: GET/POST

Syntax:

http://<servername>/cgi-bin/camctrl/eCamCtrl.cgi?channel=<value>&stream=<value>

[&move=<value>] – Move home, up, down, left, right

[&auto=<value>] – Auto pan, patrol

[&zoom=<value>] – Zoom in, out

[&zooming=<value>&zs=<value>] – Zoom without stopping, used for joystick

[&vx=<value>&vy=<value>&vs=<value>] – Shift without stopping, used for joystick

[&x=<value>&y=<value>&videosize=<value>&resolution=<value>&stretch=<value>] – Click on

image

(Move the center of image to the coordination (x,y) based on resolution or videosize.)

[ [&speedpan=<value>][&speedtilt=<value>][&speedzoom=<value>][&speedapp=<value>] ] – Set

speeds

[&return=<return page>]

Example:

http://myserver/cgi-bin/camctrl/eCamCtrl.cgi?channel=0&stream=0&move=right

http://myserver/cgi-bin/camctrl/eCamCtrl.cgi?channel=0&stream=1&vx=2&vy=2&vz=2

http://myserver/cgi-bin/camctrl/eCamCtrl.cgi?channel=0&stream=1&x=100&y=100&

videosize=640x480&resolution=640x480&stretch=0

PARAMETER VALUE DESCRIPTION

channel <0~(n-1)> Channel of video source.

1 2 ... 182 183 184 185 186 187 188 189 190 191 192 ... 212 213

No comments

Vivotek IP8152 User Manual Page 187