FD7141(V)
EN - 9EnglishNetwork CameraModel No: FD7141Made in TaiwanThis device complies with part 15 of the FCC rules. Operation is subject to the following two
EN - 10For further setup, please refer to the user's manual on the software CD.http://192.168.5.109/index.htmlReady to Use 61. Access the Network
EN - 11EnglishBased on the live image retrieved from the camera, adjust the camera lens by doing the following:WT8NDO NOT over tighten the controllers
EN - 12Attach the dome cover to camera. Secure the three dome screws with the supplied screwdriver. Finally, make sure all parts of the camera are sec
P/N:625007701G Ver.1.1Copyright 2009 VIVOTEK INC. All rights reserved. c
EN - 1EnglishPower off the Network Camera as soon as smoke or unusual odors are detected.Contact your distributor in the event of occurrence.Refer to
EN - 2Software CDFD7141 (FD7141V)Quick Installation Guide / Warranty CardAlignment Sticker / Ceiling Hole Template StickerBottom Base / Plastic Cover
EN - 3EnglishTilt ScrewSD Card SlotIR LEDsReccessed Reset ButtonN.C.N.C.N.C.AC24VAC24VFocus ControllerZoom ControllerImage Adjustment ScrewStatus LEDL
EN - 4Record the MAC address under the camera base before installing the camera.Network CameraModel No: FD7141Made in TaiwanThis device complies with
EN - 5EnglishFirst, use a screwdriver to loose the three screws and detach the dome cover from the camera base. Then, follow the steps below to instal
EN - 6Wall mount with the bottom base1. Attach the supplied alignment sticker to the wall. 2. Using the 10 circles on the sticker, drill 2 pilot holes
EN - 7EnglishGeneral Connection (without PoE)N.C.N.C.N.C.AC24VAC24VPOWERCOLLISIONLINKRECEIVEPARTITION12345Network Deployment41. If you have external
EN - 8Power over Ethernet (PoE)POWERCOLLISIONLINKRECEIVEPARTITION12345N.C.N.C.N.C.AC24VAC24VPoE SwitchPOWERCOLLISIONLINKRECEIVEPARTITION12345N.C.N.C.N
Comments to this Manuals