Vivotek ND8401 Installation Guide download pdf (Page 8)

EN - 7

English

Initial Conguration

1. Once your NVR is started, you will be prompted by the Setup Wizard. You should then

begin the initial setup. The system is booted from an embedded IDE ash. No software

installation is required.

2. Enter the default User name and Password as admin & admin. It is recommended you

change the password later to prevent unauthorized access.

3. Click Next to proceed with conguration and follow the onscreen instructions to nish the

conguration process.

4. Note the following when you move to the Network page:

4-1. If your local network has a DHCP server, you can select the "Get IP address

automatically (DHCP)."

4-2. If your LAN port connects to an isolated switch with cameras attached to it, you can

manually assign IP addresses to cameras, and the address for the LAN port itself.

The default static IP for the LAN port is

192.168.1.10.

4-3. Connect your WAN port to a router or

AP with the routing capability and then

to a DSL or Cable modem.

5. On the Disk page, Select disk drives by

clicking the checkboxes in front of the listed

disk drives.Select Build single disk, Build

RAID0, RAID1, or other option from the

Disk conguration pull-down menu. Click

Apply and wait for a few minutes for the

conguration to take effect.

Refer to the description available with

every disk volume type on the screen, such

as those for RAID0 and RAID1.

You must install at least one hard drive

for the initial conguration. Otherwise,

the LiveClient console will not start.

NOTE:

1 2 3 4 5 6 7 8 9 10 11

No comments

Vivotek ND8401 Installation Guide Page 8