Vivotek 9520 User Manual download pdf (Page 41)

- 41 -

Restoring the factory defaults will erase any

previous settings. Reset or restore the system after

power on.

Appendix

A. Troubleshooting

Status LED

The following table lists the LED patterns in general:

Condition LED color

Loading system after power on Steady amber (green and blinking red)

During booting procedure Steady amber

Detecting and setting network Steady amber (green + red) until IP address

is confirmed

After network is setup (system up) Blinking green / amber every second

and

steady green

During the upgrade firmware process Blinking green / amber every second and

fast blinking red

Reset and restore

There is a button at the back of the Network Camera. It is used to reset the system or

restore the factory default settings. Sometimes resetting the system sets the system

back to normal state. If the system problems remain after reset, restore the factory

settings and install again.

RESET: Click on the button.

RESTORE:

1. Press on the button continuously.

2. Wait for self-diagnostic to run twice.

3. Free the button as soon as the second self-diagnostic starts.

1 2 ... 36 37 38 39 40 41 42 43 44

No comments

Vivotek 9520 User Manual Page 41