VIVOTEK - A Leading Provider of Multimedia Communication Solutions
User's Manual - 7
3� Feed power to the Network Camera and connect it to the Internet� For more information,
please refer to Network deployment on page 9 for details�
4. Install the “Installation Wizard 2“ to assign IP address to the Network Camera. For more
information, please refer to Software installation on page 12 for details�
5� Access to the Network Camera from the Internet� For more information, please refer to
Accessing the Network Camera on page 13 for details�
6� Based on the live image retrieved from the camera, adjust the camera lens as following steps�
To adjust the viewing angle
■ Loosen the pan screw, then turn the lens module left and right� Upon completion,
tighten the pan screw�
■ Loosen the tilt screws on both side of the camera, then turn the lens module up and
down� Upon completion, tighten the tilt screws�
■ Loosen the image adjustment screw, then turn the lens to adjust the image orientation�
Upon completion, tighten the image adjustment screw�
Alignment sticker
When mounting to a ceiling
Through the two holes on each side of the camera base,
insert the supplied two screws to corresponding holes and
secure them with a screwdriver�
When mounting to a wall
■ Attach the alignment sticker to the wall�
■ Through the two circles on the sticker, drill two pilot holes into the wall�
■ Hammer the supplied plastic anchors into the holes�
■ Align the two holes on each side of the camera base with the two
plastic anchors on the wall, insert the supplied screws to corresponding
holes and secure them with a screwdriver�
Rotate the screw
Turn the lens
Audio Out Mic. In Ext. Int.
1 2 3 4
Audio Out Mic. In Ext. Int.
1 2 3 4
1
Audio Out Mic. In Ext. Int.
1 2 3 4
2
3
Loosen
Tighten
Loosen
Tighten
Loosen
Tighten
Comments to this Manuals