Vivotek FD8166 User Manual download pdf (Page 9)

VIVOTEK

User's Manual - 9

Mounting the Network Camera - Ceiling or Wall Mount

1. Use the curved slots on the camera as a template to mark where holes will be drilled on

the ceiling. Drill two holes into the ceiling; and hammer in the plastic anchors.

2. Drill another hole if you want to route cables through the ceiling or wall.

3. Connect and route an Ethernet cable through the ceiling or wall.

4. Attach the Network Camera to the ceiling using two included screws.

NOTE:

1. Do not completely tighten the mounting screws

in the screw slots yet. You may need to turn the

camera left or right for a best shooting direction

later.

2. The camera can only be powered by PoE. There

is no DC or AC input connector.

3. As shown on the left, you may also route cable

from the side.

Routing hole

position

LED Denitions

Item LED Status Description

1 Steady Red Power on and system boot-

ing

Red LED off Power off

2 Steady Red + blinking Green every 1 sec. (Green LED on

for 1 sec and off for another)

Network heartbeat

Steady Red + Green LED off Network disconnected

3 Blinking Red every 0.15 sec. + Blinking Green every 1 sec.

(Red LED on for 0.15 sec. and Green LED on for 1 sec. and

off for another)

Upgrading rmware

4 Blinking Red every 0.15 sec. + blinking Green every 0.15

sec.

Restoring defaults

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 194 195

No comments

Vivotek FD8166 User Manual Page 9