Vivotek IP3133 User Manual download pdf (Page 7)

- 6 -

www.vivotek.com

Installation

Hardware installation

Please verify that your product package contains all the

accessories listed in the foregoing Package Contents.

Depending on the user’s application, an Ethernet cable

may be needed. The Ethernet cable should meet the specs

of UTP Category 5 and not exceed 100 meters in length.

Upon powering up, the device runs through a self-test procedure and the front LEDs will

blink between green and red a few times. If self-test passes, the LED will be green and

the Network Camera will standby for getting IP address. If self-test fails the red LED will

blink several times. Refer to Appendix A for troubleshooting.

The Network Camera will first detect Ethernet. If it does not connect to Ethernet, the

Network Camera will try WLAN. During the searching and connecting process to the

wireless access point or station, the red LED of the Network Camera will flash every

second. Until the Network Camera connects to the other wireless device, the red LED

will become lighted. Operating in either network mode, the green LED will flash every

second as heartbeat to indicate alive.

To install in Ethernet

Make sure the Ethernet is firmly connected to a switch hub. After attaching the Ethernet

cable plug in the power adapter. If the LED turns out to be steady green after self-test, go

Connect the power adapter jack to the Network

Camera before plugging in to the power socket. This will

reduce the risk of accidental electric shock.

1 2 3 4 5 6 7 8 9 10 11 12 ... 67 68

No comments

Vivotek IP3133 User Manual Page 7