Vivotek IP7137 User Manual download pdf (Page 45)

VIVOTEK - A Leading Provider of Multimedia Communication Solutions

User's Manual - 45

Restoring the factory defaults

will erase any previous settings.

Reset or restore the system after

power on.

Appendix

A. Troubleshooting

Status LED

The following table lists the LED patterns in general.

Condition LED color

Loading system after power on Steady blue

During booting procedure Steady blue and red

Detecting and setting network Steady blue and blink red till IP address is

confirmed

After network is setup (system up) Blink blue every second and steady red

During the upgrade firmware process Blink blue every second and fast blink red

Reset and restore

There is a button in the back of the Network Camera. It is used

to reset the system or restore the factory default settings.

Sometimes resetting the system sets the system back to

normal state. If the system problems remain after reset,

restore the factory settings and install again.

RESET: Click on the button.

RESTORE: 1. Press on the button continuously.

2. Wait for self-diagnostic to run twice.

3. Free the button as soon as the second

self-diagnostic starts.

B. URL commands of the Network Camera

For some customers who already have their own web site or web control application,

the Network Camera can be easily integrated through convenient URLs. This section

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 65 66

No comments

Vivotek IP7137 User Manual Page 45