Vivotek IP8162 Specifications download pdf (Page 86)

VIVOTEK

86 - User's Manual

■ Transparent HTTP Tunnel: HTTP tunnel is useful when exerting commands over the Internet.

Response time can be significantly reduced� You can use UART commands to build a Transparent

HTTP Tunnel� The UART commands will be sent through HTTP tunnel established between the RS-

485 device and the linked camera� For detailed application notes, please refer to URL Commands on

page 118 or http://www.vivotek.com/downloadles/support/faq/172_document_2.pdf.

Preset positions

If you select DynaDome/SmartDOME, Lilin PIH-7x00, or Pelco D, Pelco P protocol, or Samsung scc643

protocol as the PTZ driver and click the Save button, the Preset Position button will be enabled� Click

Preset Position to open the settings page� (The Preset Position button is available when a driver is

selected)� You can also select preset positions for the camera to patrol� A total of 20 preset positions can

be congured.

Please follow the steps below to preset a position:

1� Adjust the shooting area to the desired position using the PTZ buttons on the upper right of the

window� The default Home position is set as the center position�

2� Enter a name for the preset position, which is up to forty characters in length� Click Add to enable the

settings� The preset positions will be displayed under the User preset locations panel�

3. To add additional preset positions, please repeat steps 1~2.

4� Select multiple preset positions each by a click on its checkbox and click Save to enable the settings�

5� The positions saved will appear in the Go to drop down list on the Home page�

6� To remove a preset position from the list, select it and click Remove�

2011/03/10 17:08:56

2011/03/13 17:08:56

x2.1

Functions are the same

as the Control Panel on

the home page

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 198 199

No comments

Vivotek IP8162 Specifications Page 86