Vivotek PZ6124 Installation Guide download pdf (Page 8)

- 4 -

www.vivotek.com

T: 886-2-82455282

F: 886-2-82455532

Installation

Hardware Installation

Please verify that your product package contains all

the accessories listed in the foregoing Package

Contents. Depending on the user’s application, an

Ethernet cable may be needed. The Ethernet cable

should meet the specs of UTP Category 5 and not

exceed 100 meters in length.

Connect the power adapter jack to the Network

Camera before plugging in to the power socket. This

will reduce the risk of accidental electric shock.

Upon powering up, the device runs through a self-test procedure and the front LEDs

will blink between green and red for a few times. If self-test passes, the LEDs will shut

off and the Network Camera will be on stand-by and ready for software installation. If

self-test fails the red LED will blink several times. Refer to Appendix A for

troubleshooting.

The Network Camera will first detect Ethernet. If it does not connect to Ethernet, the

Network Camera will try WLAN. During the searching and connecting process to the

wireless access point or station, the red LED of the Network Camera will flash every

second. Until the Network Camera is connected to the other wireless device, the red

LED will become lighted. Operating in either network mode, the green LED will flash

every second as heartbeat to indicate alive.

To install in Ethernet

Make sure the Ethernet is firmly connected to a switch hub. After attaching the

Ethernet cable plug in the power adapter. If the LED turns out to be steady green after

self-test, go to next paragraph “Software Installation”. If the Ethernet is not available,

the Network Camera will switch to wireless LAN mode.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 94 95

No comments

Vivotek PZ6124 Installation Guide Page 8