Vivotek SF8174 User Manual download pdf (Page 69)

VIVOTEK

User's Manual - 69

Day/Night

Switch to B/W in night mode

Select this checkbox to enable the Network Camera to automatically switch to Black & White display

during the night mode.

Turn on external IR illuminator in night mode

If your camera is installed with an IR illuminator and the digital output signals are connected to it, you can

let system rmware turn on the supplementary illuminator during low-light conditions.

IR cut lter

With a removable IR-cut lter, this Network Camera can automatically remove the lter to let Infrared light

pass into the sensor during low light conditions.

■ Auto mode (The Day/Night Exposure Prole will not be available if Auto mode is selected)

The Network Camera automatically removes the lter by judging the level of ambient light.

■ Day mode

In day mode, the Network Camera switches on the IR cut lter at all times to block infrared light from

reaching the sensor so that the colors will not be distorted.

■ Night mode

In night mode, the Network Camera switches off the IR cut lter at all times for the sensor to accept

infrared light, thus helping to improve low light sensitivity.

■ Synchronize with digital input

The Network Camera automatically removes the IR cut filter when a digital input is triggered, for

example, when the camera is accompanied by an external IR light that comes with its own sensor and

provides a signal to the camera. Some camera housings come with such mechanism.

■ Schedule mode

The Network Camera switches between day mode and night mode based on a specied schedule.

Enter the start and end time for day mode. Note that the time format is [hh:mm] and is expressed in

24-hour clock time. By default, the start and end time of a day mode are set to 07:00 and 18:00.

Sensitivity

Tune the responsiveness of the IR lter to lighting conditions as Low, Normal, or High.

When completed with the settings on this page, click Save to enable the settings.

If you want to configure another sensor setting for a specific lighting condition in day/night/schedule

mode, please click Prole to open the Prole settings page as shown below.

Please follow the steps below to setup a prole:

1. Check Enable and apply this prole.

2. Select the applied mode: Day mode, Night mode, or Schedule mode. Please manually enter a range

of time through which you want the Schedule mode to apply.

3. Congure Exposure control settings in the folowing columns. Please refer to the previous page for

detailed information.

4. Click Save to enable the setting and click Close to exit the window.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 243 244

No comments

Vivotek SF8174 User Manual Page 69