Vivotek IP7133 (WIRED) User Manual download pdf (Page 90)

VIVOTEK - A Leading Provider of Multimedia Communication Solutions

90 - User's Manual

Electromagnetic Compatibility (EMC)

FCC Statement

This device compiles with FCC Rules Part 15� Operation is subject to the following two conditions�

■ This device may not cause harmful interference, and

■ This device must accept any interference received, including interference that may cause undesired

operation�

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant

to Part 15 of the FCC Rules� These limits are designed to provide reasonable protection against harmful

interference in a residential installation� This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that interference will not occur in a partial

installation� If this equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

■

Reorient or relocate the receiving antenna�

■

Increase the separation between the equipment and receiver�

■

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected�

■

Consult the dealer or an experienced radio/TV technician for help�

Shielded interface cables must be used in order to comply with emission limits�

CE Mark Warning

This is a Class B product� In a domestic environment, this product may cause radio interference, in which

case the user may be required to take adequate measures�

This device (IP7134) complies with the essential requirements of the R&TTE Directive 1999/5/EC� The

following test methods have been applied in order to prove presumption of conformity with the essential

requirements of the R&TTE Directive 1999/5/EC�

This device (IP7134) is a 2.4 GHz wideband transmission system (transceiver), intended for use in all EU

member states and EFTA countries, except in France and Italy where restrictive use applies�

In Italy the end-user should apply for a license at the national spectrum authorities in order to obtain

authorization to use the device for setting up outdoor radio links and/or for supplying public access to

telecommunications and/or network services�

This device (IP7134) may not be used for setting up outdoor radio links in France and in some areas

the RF output power may be limited to 10 mW EIRP in the frequency range of 2454 – 2483.5 MHz. For

detailed information the end-user should contact the national spectrum authority in France�

Liability

VIVOTEK Inc� cannot be held responsible for any technical or typographical errors and reserves the right

to make changes to the product and manuals without prior notice� VIVOTEK Inc� makes no warranty

of any kind with regard to the material contained within this document, including, but not limited to, the

implied warranties of merchantability and fitness for any particular purpose�

1 2 ... 85 86 87 88 89 90

Comments to this Manuals

No comments

Vivotek IP7133 (WIRED) User Manual Page 90

Comments to this Manuals

Related products and manuals for Video surveillance systems Vivotek IP7133 (WIRED)