Vivotek IP71353 User Manual download pdf (Page 45)

- 43 -

www.vivotek.com

Maintenance

Three actions can be selected

“reboot” click the reboot button to restart system

“factory default” Click on Factory default button on the configuration page to restore

the factory default settings. Any changes made so far will be lost and the system will be

reset to the initial factory settings. The system will restart and require the installer

program to set up the network again.

“upgrade firmware” Select the firmware file and click upgrade button

- 44 -

www.vivotek.com

Restoring the factory defaults

will erase any previous settings.

Reset or restore the system after

power on.

Appendix

A. Troubleshooting

Status LED

The following table lists the LED patterns in general.

Condition LED color

Loading system after power on Steady blue

During booting procedure Steady blue and red

Detecting and setting network Steady blue and blink red till IP address is

confirmed

After network is setup (system up) Blink blue every second and steady red

During the upgrade firmware process Blink blue every second and fast blink red

Reset and restore

There is a button in the back of the Network Camera. It is

used to reset the system or restore the factory default

settings. Sometimes resetting the system sets the system

back to normal state. If the system problems remain after

reset, restore the factory settings and install again.

RESET: Click on the button.

RESTORE: 1. Press on the button continuously.

2. Wait for self-diagnostic to run twice.

3. Free the button as soon as the second

self-diagnostic starts.

User's Manual - 44

VIVOTEK - A Leading Provider of Multimedia Communication Solutions

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 66 67

No comments

Vivotek IP71353 User Manual Page 45