Vivotek IP2112 Specifications download pdf (Page 27)

FTP. Even in modem application, Network Camera will send out a connection log

whenever it dials out to an ISP or dialup server outside. If the administrator has setup

some applications in either event mode or sequential mode, Network Camera will send

out snapshots once conditions are met. To activate e-mail function, enter correct

settings of "SMTP (mail) server" and "Recipient email address". "Secondary SMTP

(mail) server" and "Secondary email address" are provided for backup connection

when the primary one fails. “Return email address” is whom the mail will return when

the SMTP server rejects upon any failure. Some ISP may reject the mail if the address is

invalid.

FTP settings

To send the log files described in the above paragraph via FTP, the SMTP server should be

erased. Administrators must enter correct "Primary FTP Server", "Primary FTP user

name" and "Primary FTP password". "Primary FTP remote folder" is the relative

sub-folder in the remote FTP server. If the port of the remote FTP server is changed other

than 21, set the real port to “Primary FTP server port”. If the local network is

protected by a firewall to prevent from initiating FTP connection from the remote FTP

server, you may be able to connect to the FTP server but unable to put any file due to

data channel connection failure. Check “Primary FTP passive mode” for passive

transfer solution. Another set of "Secondary" server settings is also provided for backup

connection.

In either e-mail or FTP, the primary server information should be entered first. If the

primary server is not set, the related FTP or email will be cancelled. Note that it may take

time to connect to the secondary server after the first one fails and it may affect some

applications when conditions happen too often.

After everything is set, click on

. A warning message will pop out for confirmation.

After clicking on

, Network Camera will automatically restart. If "Reset network

at next boot" is kept checked, perform software installation again. Otherwise Network

Camera will boot up according to the new configuration automatically.

Any change made to this page will make the system restart to validate. Make sure

every field is correctly typed before clicking on

. If Network Camera fails to response

due to erratic settings, perform the restore procedures and run software installation.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 68 69

No comments

Vivotek IP2112 Specifications Page 27