Vivotek IP8133W User Manual download pdf (Page 8)

EN - 7

English

WPS

Wireless Connection: Using the WPS Button

1. Make sure your AP (Access Point) and Operating System support WPS (Wi-Fi

Protected Setup) functions. WPS enables easy setup with compatible APs.

2. Disconnect your LAN cable, and wait for the LED to turn red.

3. Press the WPS button for 1 second. You can then hear vocal instructions (in English)

from the camera speaker.

4. Press and hold down the WPS button on your AP

(some router/AP will have a virtual button on their

management software instead). Refer to your AP's

documentation for details using its WPS functions.

When WPS conguration is done, wireless connectivity will be established and the

security encryption, such as WEP or WPA-PSK, will be synchronized with the AP.

Use the IW2 utility to nd the camera. As for IP setting, the camera's use of DHCP

or static IP is determined by your conguration on the network camera via the web-

based conguration of rmware. The camera's default is DHCP.

NOTE:

WPS Button

Wireless AP

1. WPS may not work if your AP is congured with a "hidden" SSID.

2. If no WPS-enabled AP is detected, the camera will repeat vocal instructions by

every 20 seconds, and if the camera still can not detect an AP after 2 minutes, the

wireless setup will be cancelled.

3. If a camera is assigned with a xed IP outside the AP's network segment, wireless

setup will fail.

4. A wired connection always has a higher priority, and hence wireless setup will not

take effect when the RJ45 LAN port is connected.

1 2 3 4 5 6 7 8 9 10

No comments

Vivotek IP8133W User Manual Page 8