Vivotek IP8362 Specifications download pdf (Page 7)

VIVOTEK

User's Manual - 7

Waterproof Connector

1. Disassemble the components of the waterproof connector into part (A) ~ (F) as shown above.

2. Remove the rubber stopper from the bottom of the Network Camera and secure the rubber (A)

and screw nut (B) tightly.

3. Open the back cover of the Network Camera.

4. If you have external devices such as sensors and alarms, feed the cables through the

waterproof connector (F --> E --> C --> A+B) as the illustration shown below. Then refer to

the pin denition to connect them to the general I/O terminal block. Note: The recommended

cable gauge is 2.0 ~ 2.8 mm.

5. Push the seal (C) into the housing (E).

6. Insert the seals (D) into the empty holes on the seal (C) to avoid moisture.

7. Secure the sealing nut (F) tightly.

8. Tighten the back cover.

9. Remove rubber (G) and feed the cables through the wall mount bracket.

1 Power +12V

2 Digital Output

3 Digital Input

4 Ground

5 RS485 +

6 RS485 -

7 Ground

8 Audio Input

9 Ground

10 Audio Output

87654321 109

Components of the Waterproof Connector

Seals (D)

Housing (E)

Sealing Nut (F)

Seal (C)

Screw Nut (B)

Pin Denition

Rubber (A)

Components of the Waterproof Connector

(A)+(B)

(E)

(C)

(F)

(D)

(C)

(E)

(F)

(C)

(F)

(G)

1 2 3 4 5 6 7 8 9 10 11 12 ... 49 50

Comments to this Manuals

No comments

Vivotek IP8362 Specifications Page 7

Comments to this Manuals

Related products and manuals for Security cameras Vivotek IP8362