Vivotek IP8371E User Manual download pdf (Page 11)

VIVOTEK

User's Manual - 11

1. Disassemble the components of the waterproof connector into part (A) ~ (E) as shown

above.

2. Open the rear cover of the Network Camera.

3. Remove the rubber stopper from the bottom of the Network Camera and secure the

screw nut (A) tightly.

4. You may choose to use AC24V or DC12V inputs as power source, please feed the

power lines through the wall mount bracket and the waterproof connector (E --> D -->

B --> A) as illustrated below. Pass power lines through the rubber seal (B) and then

connect the power lines to the terminal block.

5. If you have external devices such as sensors and alarms, feed the cables through the

wall mount bracket and the waterproof connector (E --> D --> B --> A) as the illustration

shown below. Then refer to the pin denition to connect them to the general I/O terminal

block. Note: The recommended cable gauge is 2.0 ~ 2.8 mm.

6. Push the seal (B) into the housing (D).

7. Insert the seals (C) into the empty holes on the seal (B) to avoid moisture.

8. Secure the sealing nut (E) tightly.

Assembling Steps

9. Open the aluminum foil vacuum bag

and take out the desiccant bag. Attach

the desiccant bag to the inner side of the

rear cover, to under the insulation pad,

and then tighten the rear cover. (Please

replace the desiccant bag with a new one

whenever you open the rear cover.)

9-2

9-1

(E)

(D)

(B)

(A)

(C)

(B)

(D)

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 202 203

No comments

Vivotek IP8371E User Manual Page 11