Vivotek TC5633 Installation Guide download pdf (Page 9)

- 8 -

www.vivotek.com

T: 886-2-82455282

F: 886-2-82455532

Software Installation

At the end of the hardware installation, users can use “Installation Wizard 2” program

included in the product CDROM to find the location of the Network Camera. There may be

many Network Cameras in the local network. Users can differentiate the Network

Cameras with the serial number. The serial number is printed on the labels on the carton

and the back of the Network Camera body. Please refer to the user’s manual of

Installation Wizard 2 for details.

Initial Access to the Network Camera

Check Network Settings

The Network Camera can be connected either before or immediately after software

installation onto the Local Area Network. The Administrator should complete the

network settings on the configuration page, including the correct subnet mask and IP

address of gateway and DNS. Ask your network administrator or Internet service

provider for the detail information. By default the Network Camera requires the

Administrator to run installation every time it reboots. If the network settings are to

remain unchanged, disable the Install option. Refer to “Network settings” on the

System Configuration page for details. If any setting is entered incorrectly and

cannot proceed to setting up the Network Camera, restore the factory settings

following the steps in the “Troubleshooting” chapter of the Appendix.

Add Password to Prevent Unauthorized Access

The default Administrator’s password is blank and the Network Camera initially will

not ask for any password. The Administrator should immediately implement a new

password as a matter of prudent security practice. Once the Administrator’s

password is saved, the Network Camera will ask for the user’s name and password

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 90 91

No comments

Vivotek TC5633 Installation Guide Page 9