Vivotek V User Manual download pdf (Page 8)

www.vivotek.com

T: 886-2-82455282

F: 886-2-82455532

Installation

Hardware Installation

Please verify that your product

package contains all the accessories

listed in the foregoing Package

Contents. Depending on the user’s

application, an Ethernet cable may be

needed. The Ethernet cable should

meet the specs of UTP Category 5 and

not exceed 100 meters in length.

Connect the power adapter jack to

the Network Camera before plugging in

to the power socket. This will reduce

the risk of accidental electric shock.

Upon powering up, the device runs through a self-test procedure and the front LEDs

will blink between green and red for a few times. If self-test passes, the LEDs will shut

off and the Network Camera will be on stand-by and ready for software installation. If

self-test fails the red LED will blink several times. Refer to Appendix A for

troubleshooting.

The Network Camera will first detect Ethernet. If it does not connect to Ethernet, the

Network Camera will try WLAN. During the searching and connecting process to the

wireless access point or station, the LED of the Network Camera will keep red. Until

the Network Camera is connected to the other wireless device, the LED will become

green and flash. Operating in either network mode, the green LED will flash every

second as heartbeat to indicate alive.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 90 91

No comments

Vivotek V User Manual Page 8