Vivotek VIVOTEK IP8352, Network Camera, Supreme Series, with 1.3 Megapixel, with Focus Assist and WDR Enhanc User Manual download pdf (Page 101)

VIVOTEK

User's Manual - 101

Applications > DI and DO

Advanced Mode

Digital input: Select High or Low to dene the activate status for the digital input. The Network Camera's

current status is shown on the right�

Digital output: Select Grounded or Open to define normal status for the digital output� The Network

Camera will show whether the trigger is activated or not�

Set up the event source as DI on Event > Event settings > Trigger. Please refer to page 86 for detailed

information�

Applications > Tampering detection

This section explains how to set up camera tamper detection� With tamper detection, the

camera is capable of detecting incidents such as redirection, blocking or defocusing, or even

spray paint�

Please follow the steps below to set up the camera tamper detection function:

1� Check Enable camera tampering detection�

2� Enter the tamper trigger duration� (10 sec� ~ 10 min�) The tamper alarm will be triggered only when the

tampering factor (the difference between current frame and pre-saved background) exceeds the

trigger threshold�

3� Set up the event source as Camera Tampering Detection on Event > Event settings > Trigger.

Please refer to page 86 for detailed information�

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 181 182

No comments

Vivotek VIVOTEK IP8352, Network Camera, Supreme Series, with 1.3 Megapixel, with Focus Assist and WDR Enhanc User Manual Page 101