Vivotek 4X-PT7135 Specifications download pdf (Page 7)

VIVOTEK - A Leading Provider of Multimedia Communication Solutions

User's Manual - 7

Reboot: Press and release the indented reset button� All status LED will extinguish and then

power on again� Wait for the Status LED to blink and then become steady green in normal state�

It takes about 30 seconds to complete the procedure�

Restore: Press the reset button continuously for over 3 seconds� All status LED will extinguish

and then power on again� Wait for the Status LED to blink and then become steady green in

normal state� Note that all settings will be restored to factory default� It takes about 50 seconds

to complete the procedure�

Installation

Hard Disk installation

Before using the Network Video Recorder, the rst step is to install a SATA hard disk for re-

corded video� Please follow the steps below:

1� Make sure the power is off�

2. Use a screwdriver to loose ve screws, and then slide to remove the upper cover.

3� Loose the screw and take out the hard disk bracket�

4� Put your hard disk into the bracket, and secure it with the supplied four screws�

5� Place your hard disk into the Network Video Recorder�

6� Slide the hard disk as the picture shows, and then secure it with the original screw�

7. Attach the upper cover, and then secure it with the original ve screws.

NOTE

► Please remember to format the hard disk

before strating recording� Please refer to

maintenance on page 37�

Power POE Status HDD WAN LAN1 LAN2 LAN3 LAN4

NR7401 Network Video Recorder

Steady green in normal state

1 2 3 4 5 6 7 8 9 10 11 12 ... 50 51

No comments

Vivotek 4X-PT7135 Specifications Page 7