Vivotek FD8371EV User Manual download pdf (Page 12)

VIVOTEK

12 - User's Manual

1. Disassemble the components of the

waterproof connector into parts (A) ~ (F)

as shown above.

2. Place the screw nut (E) on the Power and

GPIO opening.

3. Feed the power cables through the

waterproof connector (F --> E --> D -->

B --> A) as the illustration shows. Then

connect the power cables to the power

source. Note: There are 8 holes on the

seal (D), and the widest holes with a crack

on the side are specic for power cables.

4. If you have external devices such as

sensors and alarms, feed the cables

through the waterproof connector (F --> E

--> D --> B --> A) as previously described.

Assembling Steps

Sealing Nut (A)

Housing (B)

Seals (C)

Seal (D)

Screw Nut (E)

Hex Nut (F)

Waterproof Connector

(A)

(B)

(D)

(E)

(F)

Refer to the pin denition to connect them

to the general I/O terminal block. Note:

The recommended cable gauge is 2.0 ~

2.8 mm.

5. Push the seal (D) into the housing (B).

6. Insert the seals (C) into unused holes on

the seal (D) to avoid moisture.

7. Secure the sealing nut (A) tightly and hex

nut (F) from the bottom of the camera.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 210 211

Comments to this Manuals

No comments