Vivotek IP32133 User Manual download pdf (Page 9)

- 8 -

www.vivotek.com

T: 886-2-22404099

F: 886-2-22404097

Software installation

In the following content, "user" refers to those who can access Network Camera and

"administrator" refers to the supervisor who can configure Network Camera and grant

users access.

When completing the hardware installation, administrators need to run the Installer

program included in the product CDROM to locate the newly installed Network Cameras.

Any Network Camera standby for software installation will be captured by the Installer

program. Therefore there may be several entries shown in the window. Administrators

may differentiate the Network Cameras with the serial number and click on the entry

with "Assigned" field labeled "No" to perform software installation. The serial number is

printed on the labels on the carton and the rear panel of Network Camera body.

To install Network Camera for wireless usage, it is recommended to install in

Ethernet first. After successfully entering the network configuration page, input the

correct WLAN settings, remove the Ethernet cable and recycle the power to work in

WLAN.

The IP address shown in

"Current IP Address" field

depends on the local network.

It may get from the DHCP

server for the administrator's

reference. If there is no DHCP

server, administrators can

choose any neighbor IP

address of the PC. The

Installer program will check

the IP address automatically;

there will be a warning

message if it conflicts with

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 70 71

No comments

Vivotek IP32133 User Manual Page 9