Vivotek IP8331 User Manual download pdf (Page 5)

EN-4

Hardware Installation

1. Loose the waterproof connector, and then remove the rubber.

2. Loose the back cover.

3. Tear down the aluminum foil vacuum bag and take out the moisture absorber. Attach

the supplied moisture absorber to the inner side of the Network Camera. (Please

replace the moisture absorber with a new one if you open the back cover after

installation.)

4. Make sure all cable lines are securely connected.

5. Tighten the back cover, rubber and waterproof connector.

6. Secure the Network Camera to the wall/ceiling by the supplied camera stand.

Silica gel

Ceiling Mount

Wall Mount

Note

If you want to use your own cable lines, please loose two supplied screws and take out

the power board. Then be careful to make connections as the illustration below.

Upper Side

Bottom Side

Power Cord

Terminal Block (from left to right)

1: AC24V (red)

2: AC24V (red)

3: DI (white)

4: GND (black)

Ethernet Cable

Screws

1 2 3 4 5 6 7 8 9 10

No comments

Vivotek IP8331 User Manual Page 5