Vivotek MD7530 Specifications Page 5

  • Download
  • Add to my manuals
  • Print
  • Page
    / 157
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 4
VIVOTEK
User's Manual - 5
Hardware Reset
The reset button is used to reset the system or restore the factory default settings Sometimes
resetting the system can return the camera to normal operation If the system problems remain
after reset, restore the factory settings and install again�
Reset: Press and release the recessed reset button with a paper clip or thin object Wait for the
Network Camera to reboot�
Restore: Press and hold the recessed reset button until the status LED rapidly blinks Note that
all settings will be restored to factory default Upon successful restore, the status LED will blink
green and red during normal operation�
Installation
Hardware Installation
First, use the supplied screwdriver to detach the dome cover from the camera base� Insert your MicroSD/
SDHC Card if necessary
Then, follow the steps below to install the camera to either the ceiling or the wall:
1� Attach the supplied alignment sticker to the ceiling/wall�
2� Using the 3 screw circles on the sticker, drill 3 pilot holes into the ceiling/wall� Then hammer
the plastic anchors into the holes if necessary
3� This Network Camera can be mounted with the cable routed through the ceiling/wall or from
the side� If you want to feed the cable through the ceiling/wall, drill a cable hole A as shown in
the picture� If the cable goes through the side of the dome cover, please remove the rubber
stopper (B)�
Network Camera
Model No: MD7530
Made in Taiwan
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Pat. 6,930,709
RoHS
V I
MAC:0002D107258A
Record the MAC address
before installing the camera�
Reset Button
Status LED
Dome Cover
Tamper-proof Screw
Camera Base
Rubber Stopper
Page view 4
1 2 3 4 5 6 7 8 9 10 ... 156 157

Comments to this Manuals

No comments