Vivotek FD7131 Specifications download pdf (Page 6)

VIVOTEK - A Leading Provider of Multimedia Communication Solutions

6 - User's Manual

Hardware Reset

The reset button is used to reset the system or restore the factory default settings� Sometimes

resetting the system can return the camera to normal operation� If the system problems remain

after reset, restore the factory settings and install again�

Reset: Press and release the indented reset button with a paper clip or thin object� Wait for the

Network Camera to reboot�

Restore: Press and hold the reset button until the status LED rapidly blinks� It takes about 30

seconds� Note that all settings will be restored to factory default� Upon successful restore, the

status LED will blink green and red during normal operation�

Installation

Hardware Installation

1� Use the supplied screwdriver to detach the dome cover from the camera base� Then, follow

the steps below to install the camera; either to a ceiling or to a wall�

Installation Tips

Before installing the camera, look for a spot that best suits your needs� The built-in PIR sensor

is designed to be triggered when a person enters its detection range� Therefore, it is crucial to

install the camera at a place with the PIR sensor facing the desired direction� (The sensitivity

of PIR sensor depends on object size and temperature differences between the object and the

background environment�)

I/O

Audio Out Mic. In Ext. Int.

1 2 3 4

Top view

Side view

Indented Reset Button

Status LED

1 2 3 4 5 6 7 8 9 10 11 ... 121 122

No comments

Vivotek FD7131 Specifications Page 6