Vivotek IP3132 Specifications download pdf (Page 6)

- 5 -

www.vivotek.com

T: 886-2-22404099

F: 886-2-22404097

Installation

Hardware installation

All necessary accessories can be found in the product

package except for the Ethernet cable that depends on the

user’s environment. The Ethernet cable should meet UTP

category 5 that cannot exceed 100 meters.

As soon as the power adapter is plugged into the utility socket, the front LED will switch

between green and red for several times. After passing the self-test, the LED will shut

off and Network Camera will standby for software installation. Otherwise refer to

Appendix A for troubleshooting.

Network Camera provides a general I/O terminal block with one digital input and one

relay switch for device control. Pin 1 and pin 2 can be connected to an external sensor

and the state of voltage will be monitored from the initial state 'LOW'. The relay switch

of pin 3 and pin 4 can be used to turn on or off the external device.

1 DI- INPUT (Initial state of DI is low)

2 DI+ INPUT (Max. 50mA, 12VDC)

3 SW_COMMON OUTPUT (open from SW_OPEN at initial state)

(close with SW_OPEN when set DO to ON)

4 SW_NOPEN OUTPUT (Max. 1A, 24VDC or 0.5A, 125VAC)

Connect the jack of the power adapter to Networ

Camera prior to plugging the utility end into the utility

power socket. It will reduce accidental electric surge

shock.

Consult with the dealer of the peripherals for correct installation.

1 2 3 4 5 6 7 8 9 10 11 ... 62 63

No comments

Vivotek IP3132 Specifications Page 6