Vivotek IP3136 Installation Guide download pdf (Page 49)

- 47 -

www.vivotek.com

Appendix

A. Troubleshooting

Status LED

After powering up, the Network Camera performs a self-diagnostic to detect any

hardware defects. The following table lists the LED patterns in general. In case of any

fatal error, the LED will blink in a pattern other than those below.

Condition LED color

During self-diagnostic after power on Blink in interchanged green and red

Ethernet signal is lost Steady red till Ethernet is detected

Before network is setup Steady green till IP address is confirmed

After network is setup Blink green every second

Network is setup and audio is disabled Blink green every 4 seconds

Any hardware failure Other patterns

Reset and restore

There is a button in the back of the Network Camera. It is used to

reset the system or restore the factory default settings.

Sometimes resetting the system sets the system back to normal

state. If the system problems remain after reset, restore the

factory settings and install again.

RESET: Click on the button.

RESTORE: 1. Press on the button continuously.

2. Wait for self-diagnostic to run twice.

3. Free the button as soon as the second self-diagnostic starts.

Restoring the factory defaults will erase any previous settings. Reset or restore the

system after power on.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 64 65

No comments

Vivotek IP3136 Installation Guide Page 49