Vivotek IP6127 Installation Guide download pdf (Page 60)

www.vivotek.com

T: 886-2-82455282

F: 886-2-82455532

Appendix

A. Troubleshooting

Status LED

After powering up, the Network Camera performs a self-diagnostic to detect any

hardware defects. The following table lists the LED patterns in general. In case of any

fatal error, the LED will blink in a pattern other than those below.

Condition LED color

During self-diagnostic after power on blink between red and green

No network Red is ON

Getting IP Green is flash every 0.5 sec

Talk only / mute Green is flash every 1 sec

Listen only / Full duplex / half duplex Green is flash every 0.5 sec

Reset and Restore

At the left side of the camera there is a button

hidden in the pinhole as shown in the picture. It is

used to reset the system or restore the factory

default settings. Sometimes resetting the system

sets the system back to normal state. If the system

problems remain after reset, restore the factory

settings and install again.

RESET: Poke the wrench to click on the button.

RESTORE: 1. Poke the wrench to press on the

button continuously.

2. Wait for self-diagnostic until the LED turns

orange.

3. Withdraw the wrench.

Restoring the factory defaults

will erase any previous settings.

Reset or restore the system after

power on.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 93 94

No comments

Vivotek IP6127 Installation Guide Page 60