Vivotek sd6122v User Manual download pdf (Page 8)

- 4 -

www.vivotek.com

T: 886-2-82455282

F: 886-2-82455532

Installation

Hardware Installation

Please verify that your product package

contains all the accessories listed in the

foregoing Package Contents.

Depending on the user’s application, an

Ethernet cable may be needed. The

Ethernet cable should meet the specs of

UTP Category 5 and not exceed 100

meters in length.

Connect the power adapter jack to

the Network Camera before plugging in

to the power socket. This will reduce the

risk of accidental electric shock.

Upon powering up, the device runs through a self-test procedure and the front LEDs

will blink between green and red for a few times. If self-test passes, the LEDs will shut

off and the Network Camera will be on stand-by and ready for software installation. If

self-test fails the red LED will blink several times. Refer to Appendix A for

troubleshooting.

Alarm Cable Wiring

The alarm pins are serviceable for connecting alarm input and output devices, such as

alarm sensors, sirens or flashing lights with the surveillance system. The table shown

as follows lists the definition of alarm pins on the 22-pin connector located on the

bottom of the dome camera.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 99 100

No comments

Vivotek sd6122v User Manual Page 8