Vivotek IP8152 User Manual download pdf (Page 95)

VIVOTEK

User's Manual - 95

Transparent HTTP Tunnel: If you want to use your own RS-485 device, you can use UART

commands to build a Transparent HTTP Tunnel. The UART commands will be sent through HTTP

tunnel established between the RS-485 device and the camera. For detailed application notes,

please refer to URL Commands started on page 124 or

http://www.vivotek.com/downloadles/support/

appnote/14_document_1.pdf

Preset Positions

If you select Pelco D protocol, as the PTZ driver and click the Save button, the Preset Position

button will become available. Click on the Preset Position button to open the configuration

window. A total of 20 preset positions can be congured.

Please follow the steps below to congure preset positions:

1. Adjust the shooting area to the desired position using the buttons on the right side of the window.

2. Enter a name for the preset position, which allows for up to forty characters. Click Add to enable

the settings. The preset positions will be displayed under the Preset Location list on the left-hand

side.

3. To add additional preset positions, please repeat steps 1 and 2.

4. To remove a preset position from the list, select it from the drop-down list and click Remove.

5. The preset positions will also be displayed on the main page. Please refer to the illustration on

the next page.

6. Click Save to enable the settings.

Functions are the same as

the Control Panel on the

home page

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 211 212

No comments

Vivotek IP8152 User Manual Page 95