EN - 9EnglishFor further setup, please refer to the user's manual on the software CD.Ready to Use 61. Access the Network Camera on the LAN.2. Ret
EN - 10Based on the live image retrieved from the camera, adjust the camera lens by doing the following:DO NOT over rotate the lens. Doing so
EN - 11English2311. Rotate the black cover inside the dome cover to fit the lens shooting direction.2. Attach the dome cover to camera.3. Secure the
EN - 1EnglishPower off the Network Camera as soon as smoke or unusual odors are detected.Contact your distributor in the event of occurrence.Keep the
EN - 2Do not place the Network Camera on unsteady surfaces.Do not touch the Network Camera during a lightning storm.Do not disassemble the Network Cam
EN - 3EnglishSoftware CDFD8161ScrewdriverAlignment StickerScrews and I/O Connector Power Adapter510000210GPackage Contents1A/V CableQuick Installatio
EN - 4LensTilt Adjustment ScrewBuilt-in MicrophonePIR SensorIR LEDsPower Cord SocketEthernet 10/100 RJ45 SocketRecessed Reset ButtonAudio In1 2 3 4 AV
EN - 5EnglishFirst, use the supplied screwdriver to detach the dome cover from the camera base. Then, follow the steps below to install the camera to
EN - 6General Connection (without PoE)1. If you have external devices such as sensors and alarms, connect them to the general I/O terminal block.2
EN - 7EnglishNon-PoE SwitchPOWERCOLLISIONLINKRECEIVEPARTITION12345Power over Ethernet (PoE)POWERCOLLISIONLINKRECEIVEPARTITION12345PoE SwitchWhen using
EN - 8Network CameraModel No: FD8161Made in TaiwanThis device complies with part 15 of the FCC rules. Operation is subject to the following two condit
Comments to this Manuals